Cutting Ceramic Tile and
Ceramic Tile Cutter

The Wetsaw

A tile wetsaw is just that, a diamond cutting blade that is immersed in water to keep it cool. So with this style of cutter you will need lots of water, as well as rags to dry the tile after cutting ceramic tile.

These are very easy to use, simply mark the cut, turn on the saw and wait for it to come up to speed and slowly feed the tile into the blade. Making sure there is enough water to keep the blade cool. Most tile wetsaws have a water level indicator.

I only use wetsaws to cut around corners, and other irregular shapes that cannot be done the score and break cutter. Not because they don't work, but because it takes so much longer to do cut the tile this way. You have set up the saw outdoors, put water in the tray, then you have to walk outdoors to cut the tile, dry it off, then walk all the way back inside to check the fit. If it doesn't fit correctly guess what? Yup, you're going back outdoors cutting ceramic tile again.

Don't get me wrong these cutters have their place but it's much easier to use these only when necessary. There are also two types of these ceramic tile cutters. Ceramic tile cutting can be done on a professional style wetsaw that can be rented for say $40 a day.

Or you could buy a homeowners model for around $60 and have it for a long time. A Homeowner Wet Saw from Amazon is a good choice. I have personally owned one of these for many years and it gets plenty of use. I have had to change the blade twice now, and for how many tiles it's cut that's not too shabby. Plus it's very light in weight which makes it very easy to carry.

A homeowner model saw can also fit into a shower, so if you want to cut indoors it's possible. Keep in mind these tile saws do spray a lot of water, so keep the guard in place to contain it. I'm sorry I don't have a picture of my wetsaw but it is well worn, just shows how much it's been used. It has been cutting ceramic tile for a long time.

Tile Nippers

I gotta tell you, I'm not a fan of these cutters. They often break the tile irregularly, and sometimes they break the tile in half. They also send shards of very sharp glazing flying. The key to using nippers is to take small bites.

I would only recommend these cutters to those who have some experience with ceramic tile. The reason for that is you have to know what will be covered up by trim, or a fixture to hide the ragged edge these cutters leave.

Drilling Ceramic Tile

It may be necessary to drill ceramic tile while installing it. It's very easy to do if you take your time.

First thing is you need a drill with a masonry bit in the size you need. The masonry bit is hardened with carbide to take the stress of drilling through such a hard material.

After you mark where the hole is to be drilled simple take the bit and tap it with a hammer very, very lightly to chip the glaze a bit to prevent the bit from walking all over the tile.

Next drill your hole. It's that easy. The key is to lightly tap the bit with a hammer to chip the tile a little. Don't whack the bit with sharps blows as this will damage the bit and also potentially crack the tile. If you prefer you can use a nail or a nailset to chip the glazing it's your choice.

Drilling ceramic tile can be done before or after the tile is installed.